Difference between revisions of "OpenFOAM"
From ONELAB
(Created page with "= Introduction = [http://www.csc.fi/english/pages/elmer Elmer] is an open source (GPL) computational tool for multi-physics problems. It is developed by CSC in collaboration...") |
(→Introduction) |
||
| Line 1: | Line 1: | ||
= Introduction = | = Introduction = | ||
| − | [http://www. | + | |
| − | + | [http://www.openfoam.com OpenFOAM] is a free, open source CFD software package developed by OpenCFD Ltd at ESI Group and distributed by the OpenFOAM Foundation . | |
| − | To test ONELAB models working with OpenFOAM, | + | To test ONELAB models working with OpenFOAM, a working installation of OpenFOAM on your system is needed. |
| − | The easiest way to do so, is to install first the generic [[ONELAB virtual machine|ONELAB virtual machine]] | + | The easiest way to do so, is to install first the generic [[ONELAB virtual machine|ONELAB virtual machine]] |
by following [[ONELAB virtual machine|these instructions]]. | by following [[ONELAB virtual machine|these instructions]]. | ||
When done, log in into the virtual machine (username: "olvm", passwd: olvm) | When done, log in into the virtual machine (username: "olvm", passwd: olvm) | ||
| − | and proceed with the | + | and proceed with the Instructions of the next section. |
| − | |||
= Installation = | = Installation = | ||
Revision as of 15:16, 30 May 2014
Introduction
OpenFOAM is a free, open source CFD software package developed by OpenCFD Ltd at ESI Group and distributed by the OpenFOAM Foundation . To test ONELAB models working with OpenFOAM, a working installation of OpenFOAM on your system is needed. The easiest way to do so, is to install first the generic ONELAB virtual machine by following these instructions. When done, log in into the virtual machine (username: "olvm", passwd: olvm) and proceed with the Instructions of the next section.
Installation
The Virtual machine is configured so that Gmsh and OpenFOAM can be installed straightforwardly by issuing simple commands in a terminal. Proceed as follows.
- Step 1 - Download installation scripts
- Open a terminal by clicking on the "terminal" icon in the launcher panel and issue the command
install_scripts.sh
- Step 2 - Install Gmsh and Onelab
- Then the command
install_gmsh.sh- downloads the nightly-build of Gmsh from http://geuz.org/gmsh, install it, and place a Gmsh icon on the Desktop.
- Step 3 - Install Elmer
- The command
install_foam.sh- downloads the source code of Elmer and compile it on the virtual machine. This may take several minutes.
After these 3 steps, you have a woking installation of Gmsh and OPenFOAM on the virtual machine.
- Step 4 - Download model examples
- The model examples detailed in the next section are downloaded in a directory named
ELMERMODELSwith the command getFoamModels.sh.
